Enduramaxx Let's Be Clear About Clarifiers

Let’s Be Clear About Clarifiers

Removing suspended solids from liquids is necessary for many processes in industrial wastewater treatment.  Let’s Be Clear About Clarifiers –  Clarifiers are settling tanks, often called settlers, in addition sometimes serve for thickening in which case they are termed thickeners.  Clarifiers usually feature a built-in mechanism for continuous removal of the solids deposited by sedimentation, concentrated impurities discharged from the bottom of the tank are known as sludge while the particles that float to the surface of the liquid are called scum.

Usually, before a fluid goes to a clarifier, it undergoes coagulation and flocculation processes causing finely suspended particles to clump together to form larger and denser particles that settle more quickly. This eases separation, improving efficiency and conserving energy during the treatment cycle.  Isolating particle components first using these processes may reduce the volume of downstream treatment operations.

Forces & Flow In Clarifiers

Two dominant forces act upon the solid particles in clarifiers – gravity and particle interactions. Too high a flow can lead to turbulence and potential flow short-circuiting.  After coagulation, flocculation by mechanical paddles allows coagulates to form denser particles (flocs) to settle more easily. The stream then goes to the clarifier where the separation of clarified liquid from the solids and flocculated coagulate occurs by permitting the heavier and larger particles to settle to the bottom. The sludge requires regular removal and disposal generally through means of a tanker.  The clarified liquid often is pumped to filters to eliminate any residual particles and then often onto a filter press.

Tanks are sized to give liquid optimal residence time and economy favours using small tanks.  However, if the liquid flow rate through the tank is too high, most particles will not have sufficient time to settle. Considerable attention is focused on reducing liquid inlet and outlet velocities to minimize turbulence and promote effective settling throughout available tank volume. Internal baffles prevent fluid velocities at the tank entrance from extending into the tank and overflow weirs uniformly distribute flow from liquid leaving the tank over a wide area of the surface to minimize resuspension of settling particles.

Design Of The Clarifier

Reducing the velocity increases the hydraulic retention time inside the clarifier for sedimentation and helps to avoid excessive turbulence and mixing.  Promoting the effective settling of suspended particles means the inlet flow also should be distributed evenly across the entire cross-section of the settling zone inside the clarifier.  As a rough indication, the settling zone’s volume often is around 30–40% of the total capacity of a clarifier.

The sludge formed from the settled particles at the bottom of the clarifier if left for an extended period can become viscous creating difficulties in its removal. This sludge should be drained properly from the bottom of the tank often through positive-displacement pumps.

Enduramaxx Clarifier Tanks

Enduramaxx manufactures clarifiers up to 12m3, as we as a number of mixers for Coagulation and Flocculation for water and wastewater treatment mixing applications, for more details on the products in the Let’s Be Clear About Clarifiers article please get in touch.

Main Menu